HOUSE: NASA Mars Rover 3D model

Hi!
Before explaining, congratulations on the successful Mars landing of NASA's "Insight"!

The 3D modeling we will introduce today is also related to nasa.

It is a concept car made by parkerbrothersconcepts.

The exact name is unclear because it is a concept. I simply call it the NASA Concept Mars Rover.

The NASA-related rover is currently on display at the Kennedy Space Center in Florida, USA.

These are the pictures I used to refer to when I modeled.
It was difficult to find related pictures than I thought.

We started modeling with SolidWorks 2016.

I thought it took a long time. And looking at the records, I've been working on plans since October 2017.

Let's look at the whole exterior!

Does the overall feel a bit like a batmobile? How about you?

According to the search, the body part is divided into front and back.

The front part is used for the exploration and the rear part is used for the lab.

I did this too :)

I could not find any information clearly about how the rear end is divided. But is not it possible to divide the whole rear side only by this method? I think this.

Also, in the rear laboratory part, there are only two wheels, so I made a supporting part to balance.

Unfortunately, there was no adequate space around the legs, so it was impossible to model and characterize the cylinder.

So realistically, I think it's impossible to support with a cylinder.

Next, I changed the wheel a little bit more.

I brought this picture here.

https://www.facebook.com/pg/ParkerBrothersConcepts

The wheel seems to have a special appearance, but I do not particularly drive it.

Here I wanted to put some fun features.

Do you look like a Stainless Steamer?

The principles seem to be similar.

But the fixed parts are opposite.

In addition, it is different in that there is not a crank plate that can support the center shaft without being hindered even if it is impacted externally.